Barbecook IMPULS 3.0 BLACK Instrucciones De Instalación página 33

Note: damage arising from a fully or partly
blocked venturi tube in a burner is not cov-
ered by the guarantee and is considered
lack of proper maintenance
F
.
LIGHTING THE BURNERS
Prior to lighting the burners, all checks and
procedures detailed in the chapter 'Before
the first use' must have been carried out.
must be 'OFF'. Slowly open the gas
cylinder valve. Before opening the
control knob of one burner, wait ap-
prox. 10 seconds to allow to gas to
stabilize
ner
lighted, you only need to put the
the position 'HIGH' to light them.
LIGHTING THE BURNERS WITH THE
IGNITER
sparks
control knob of the middle burner
and turn to 'HIGH'
attempts, disconnect the gas and
wait 5 minutes before trying again.
This will allow the accumulated gas
All manuals and user guides at all-guides.com
to escape. Try again, repeating the
above steps.
the chapter 'Troubleshooting Guide'
to determine the cause and the re-
medy, or use a match as described
below.
G
LIGHTING THE BURNERS WITH A
MATCH
Left and right at the bottom of the burner
box is a small opening that can be used to
light the burners with a match, if the elec-
-
hole, approx. 13 mm from the burner
turn to 'HIGH'. The burner should
light within 5 seconds. If not, turn
-
the control knob off and wait 5
minutes to allow the gas to escape.
burner still does not light after 3
attempts, read the chapter 'Trouble-
shooting Guide'
LIGHTING THE OTHER BURNERS
been lighted, you only need to
put the control knob of the other
light them.
LIGHTING THE SIDE BURNER USING
THE IGNITER
Only for Vanilla / Kaduva Black
First open the lid of the side burner.
To light the side burner, use the igniter on
the control panel and the control knob on
the side table.
sparks.
control knob of the side burner and
turn to 'HIGH'
burner does not light immediately.
seconds, turn the control knob to
'OFF' and wait 5 minutes to allow
the gas to escape.
burner still does not light, read the
chapter 'Troubleshooting Guide' or
use a match as described below.
Note:
is 9 kg!
vessel is 220 mm
H
LIGHTING THE SIDE BURNER WITH A
MATCH
Only for Vanilla / Kaduva Black
provided
burner and turn to 'HIGH'. The bur-
ner should light within 5 seconds. If
not, turn the control knob 'OFF' and
wait 5 minutes to allow the gas to
escape.
burner still does not light, read the
chapter 'Troubleshooting Guide'
to determine the cause and the
remedy.
VISUAL CHECK OF THE FLAMES
I
HIGH
LOW
If the flames of the burners jump out of the
burner box when the barbecue is in use,
immediately turn off the control knobs.
Wait 5 minutes to allow the gas to escape
before relighting the barbecue. Read the
chapter 'Troubleshooting Guide' if the
problem persists.
Each time you light the barbecue you
www.barbecook.com 37