Safety Information - Barbecook IMPULS 3.0 BLACK Instrucciones De Instalación

by national regulations
REPLACING THE CYLINDER
When replacing the cylinder, ensure that
the control knob on the barbecue is in the
OFF position and the cylinder is closed.
Never replace a cylinder in the vicinity of
potential ignition sources.
TRANSPORT AND STORAGE OF THE
GAS CYLINDER
Although perfectly safe when handled
correctly, lack of caution may result in fire
and/or explosion.
To minimise the risks:
ding, garage or other enclosed area,
but always in a well-ventilated area
vicinity of another gas operated ap-
pliance, or in a very warm area, such
as a car or boat
reach for children
der in an upright position
cylinder, especially during transport
with a vehicle
HOSE AND REGULATOR
The hose and regulator are not supplied by
the manufacturer. Only use a hose / regula-
tor combination that complies with all local
and national provisions and standards, and
that is compatible with the couplings of the
gas cylinder used and the gas type/nomi-
nal pressure stated on the barbecue. Keep
the hose as short as possible.
non-regulated gas supply. Never try
to alter the hose or regulator in any
way whatsoever.
check the hose over its full length
sections) or excessive wear. When
you notice any damage or wear,
replace the hose before using the
barbecue, in accordance with the
national standards
must never fall onto the hose, and
the hose must never come into
contact with any hot points on the
barbecue
be protected when it is not connec-
ted to the cylinder
the ground as this could compro-
mise the tightness of the connector
36 www.barbecook.com
All manuals and user guides at all-guides.com
necting or disconnecting the cylin-
der
the hose is 1.5m
LEAKAGE TEST
A
-
B
C
-
A leakage test must be performed:
the first time
a gas part is changed
the start of the season
The leakage test must be performed
outdoors, in a well-ventilated area and not
in the vicinity of an open flame, heat or
ignition sources. No smoking! Use only a
50/50 mixture of liquid soap and water for
the leakage test. Do not use a match or an
open flame.
1. Once you have connected the cylinder
to the barbecue and all control knobs
are 'OFF', slowly open the cylinder 1
turn.
2. Rub the soap solution over all connecti-
ons and components listed below.
Check the following areas for leaks:
3. Soap bubbles indicate a leak.
4. Firmly tighten any leaky connection and
repeat the test as long as a leak is indi-
are checking the leak).
- 5. Disconnect the cylinder/control valve
and check that all control knobs are OFF.
6. Do not use the barbecue if you can-
not repair the leak. Close the cylinder
valve, remove the cylinder and contact
a qualified maintenance person for gas
appliances or the gas supplier to carry
out the appropriate repairs.
Note: the regulator may differ from the
version shown here.
PRIOR TO FIRST USE / AFTER
PROLONGED PERIOD OF NON-USE
Do not use the barbecue before you have
read, understood and checked all informa-
tion in this manual.
Ensure that:
the venturi tubes are properly placed
over the openings of the gas valves
cleaning of the burners)
come into contact with a hot surface
place
D

SAFETY INFORMATION

Natural hazards - spiders and insects:
very tiny insects may crawl into the ven-
turi tubes of the gas burners and build a
web or nest (Fig. E)
E
that could block gas flow in whole or in
part. Such a situation is indicated by a
smoky, yellow flame and/or burner that
can only be lighted with difficulty or not
at all. The gas may eventually burn
outside the venturi tube and thus cause
serious damage to your barbecue.
Should this happen, immediately close
the cylinder. Clean the burners as soon
as the barbecue has cooled down.
Remove the burner(s) as shown in Fig.
F. Clean with a pipe cleaner or brush the
venturi tubes. Put the burner back into
place in accordance with the instructi-
ons. (Fig. F) After cleaning, the venturi
tubes must be correctly placed back
over the openings of the gas valves.
-