Bosch Professional GCM 10 SD Manual Original página 52

52 | English
Setting the Standard 45° Bevel Angle (Right-
ward)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 16 to the 0° detent 15.
The lever 13 must be felt to engage in the de-
tent.
– Pull the right fence extension 19 completely
outward.
– Loosen the clamping lever 14.
– Lightly tilt the tool arm leftward out of the 0°
position via handle 5 and turn knob 39 until
the bevel angle range
– Tilt the tool arm via handle 5 rightward to the
stop (45°).
The tool storage 42 must be removed for access
to the covered set screws.
– For this, remove both the fastening screws
43 as well as the fastening nut 44.
Checking: (see figure U1)
– Set an angle gauge to 135° and place it on
the saw table 16.
The leg of the angle gauge must be flush with
the saw blade 7 over the complete length.
Adjusting: (see figure U2)
– Guide the supplied Allen key 46 (3 mm) from
outside through the smaller hole in the hous-
ing and insert it into the covered set screw
68.
– Screw the set screw in or out until the leg of
the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 14 again.
When the angle indicators 31 and 22 are not in
line with the 45° marks of scale 30 after adjust-
ing, firstly once more check the 0° setting for
the bevel angle and the angle indicators. Then
repeat the adjustment of the 45° bevel angle.
1 609 929 X04 | (13/7/10)
is indicated.
0 – 45°
Adjusting the Clamping Force of Clamping Le-
ver 14 (see figure T2)
The clamping force of clamping lever 14 can be
readjusted.
Checking:
– The clamping force of the clamping lever
must securely hold the position of the tool
arm at any bevel angle.
Adjusting:
– Loosen the clamping lever 14.
– Turn set screw 69 in anticlockwise direction
with the supplied open-end spanner 45
(17 mm) to reduce the clamping force, or in-
crease the clamping force by turning in clock-
wise direction.
– Adjust a vertical bevel angle, retighten
clamping lever 14 and check if the desired
clamping force has been reached.
Adjusting the Clamping Force of Clamp 3
(see figure V)
The clamping force of the handle clamp 3 can be
readjusted.
Checking:
– The clamping force of the clamp must se-
curely hold the handle in any of the
4 possible positions.
Adjusting:
– Open clamp 3.
– Turn both set screws 70 in anticlockwise di-
rection with the supplied Allen key 47
(1,5 mm) to reduce the clamping force, or in-
crease the clamping force by turning in clock-
wise direction.
Always adjust both set screws to the same
height.
– Shut clamp 3 and check if the desired clamp-
ing force has been reached.
Bosch Power Tools