Mettler Toledo IND310drive Manual De Instalación página 20

IND310drive Installation Manual
2. Repeat Step 1 for the other slot.
3. After releasing the front panel, lift the bottom of the front panel up and out until
4. Raise the top of the front panel until it clears the two top clips. The cover will
The openings on the bottom of the enclosure are for serial I/O, Ethernet, load cell,
and other peripheral component cables.
Once the IND310drive terminal is open, electrical connections can be made as
shown in Figure 2-2.
interface board
Compact Flash
memory card
The IND310drive terminal is designed to withstand harsh environments. However,
care must be taken when installing cables and/or connectors that enter the terminal
enclosure. To ensure a water tight seal:
•
2-2
Front Panel slots
for spring clip
removal
Figure 2-1: IND310drive Terminal Access
it completely clears the enclosure.
swing down and is hinged by two wire cables at the bottom.
COM 2
Pin 1
Load cell
socket
Figure 2-2: PCB with Associated Connectors
Pass the cables through an appropriately sized cable grip before connecting
the wires. For example, the Ethernet cable goes through the large cable gland
(see Figure 2-3).
USB Ethernet
COM 1
AC power
in
Pin 1