Mettler Toledo IND310drive Manual De Instalación página 31

The standard jumper settings are as follows:
Table 2-6: Main Printed Circuit Board
Jumpers/LEDs On Off
J1
W2 X
W3 X
X
W4
X
X
LED1
X
LED2 X
LED3 X
LED4 X
Table 2-7: Single and Dual Analog Load Cell—Scale 1
Jumpers/LEDs On Off
W1
IRQ1 X
IRQ2 X
IRQ7 X
X
W2
X
1
W3 X
W3 X
W4
CS4 X
CS3 X
CS2 X
CS1 X
LED1 X
X
1
Jumper W3 is only available on dual analog load cell boards.
IND310drive Installation Manual
Description
J1 is a five-pin jumper set. It is used for factory setup only.
No jumpers are to be installed on J1.
Hardware reset. (Always off). This jumper performs the
same functions as a power cycle. This jumper should not be
used in the field.
Software debug use. (Always on). This jumper should not
be used in the field.
Sets Com 2 to RS485 protocol.
Sets Com 2 to RS422 protocol.
Power on.
Power off. If unit is plugged in, check main power, power
connections, and fuses before contacting service.
Application software running.
Ethernet link connected.
Ethernet is active.
Description
W1 is a three-position jumper set. Only one jumper should
be connected.
When closed, this jumper sets the connected scale's load
cell setting to 2 mV/V.
When open, this jumper sets the connected scale's load cell
setting to 3 mV/V
This jumper sets Scale 2 to 2 mV/V.
No jumper on W2 sets Scale 2 to 3 mV/V
W4 is a four-position jumper set. Only one jumper should be
connected.
Power on.
Power off. If unit is plugged in, check main power, power
connections, proper seating of the board, and fuses before
contacting service.
2-13