a
I
I
ccessory
nstallatIon
nstructIons
Installing Single Tube Holder:
1. Move the 3-way rocker switch to the center, off/standby position.
2. Remove cup head, or any other accessory from the Vortex Mixer. Turn the
cup head clockwise, approximately 1/8 of a turn, (see figure 1) and then lift
the accessory straight up (see figure 2). Remove samples before removing the
accessories.
3. Align the base plate of the Single Tube Holder over the head mount of the
Vortex Mixer with the two Single Tube Holder alignment posts at the back
of the unit. Lower Single Tube Holder onto Vortex Mixer, (see figure 3) the
magnets will hold the Single Tube Holder in place. To realign this attachment,
pull up from the handle until the magnets release, check the alignment and
place again.
4. Now that the Single Tube Holder is in place, attach the cup head on the head
mount of the unit. Turn the cup head counter-clockwise until it snaps into
place, approximately 1/8 of a turn. (see figure 4)
5. Lift up on the spring loaded upper portion of the Single Tube Holder and slide
a 6,4 to 11,4cm long tube on the cup head so that the tube is aligned in the
middle (see figure 5). You are now ready to mix your sample.
1.
2.
9
(H
d
v
eavy
uty
ortex
3.
4.
5.
M
)
Ixer
EN