Puréeing - Silvercrest SHMS 300 C2 Instrucciones De Uso

Puréeing
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
ATTENTION! PROPERTY DAMAGE!
Never use the blender e for hard foodstuffs
►
such as: coffee beans, ice cubes, sugar, cereals,
chocolate, raw/hard vegetables etc. This could
result in serious damage to the appliance.
Do not use the blender e to purée boiling
►
food (e.g. soups). Remove the pot from the
hotplate before puréeing.
1) Use the blender e to purée foods.
Whisks r
Kneading
hooks t for
for stirring
kneading batter or cake
heavy doughs, mixture or
e.g. yeast for whipping
dough. cream.
2) Open the safety catch of the blender socket 4
by pushing it to the side and holding it firmly.
NOTE
The blender e can only be used if the whisks r
►
or the kneading hooks t are not installed.
3) Push the blender e into the blender socket 4
and push it down firmly. The blender e must
audibly click into place.
4) To avoid overflowing, the container used for
blending should only be filled to about 2/3 of
its capacity. Select a suitably large container.
│ GB │ MT
■ 50
NOTE
►
►
5) Press the Turbo button / 2. Keep the Turbo
ATTENTION! PROPERTY DAMAGE!
►
6) When you have finished working with the
ATTENTION! PROPERTY DAMAGE!
►
Blender e
for puréeing
fruits/
vegetables,
7) To remove the blender e from the blender
e.g. apples.
8) Remove the blender e with a snapping motion
Ensure that there is a sufficient amount of
liquid/purée in the purée container.
To ensure effective mixing of the ingredients,
the food should cover at least the lower section
of the blender e.
Do not switch the hand mixer on until the
blender e has been inserted into the ingre-
dients.
button / 2 pressed down during the whole
procedure. The appliance stops as soon as it
is released.
Do not operate the blender e for longer
than 1 minute at a time. After one minute of
use, allow the appliance to cool down fully.
blender e, release the Turbo button/ 2 and
remove the mains plug from the power socket.
Clean only the lower section of the blender e
under running water. Do not allow water to
get inside the blender e. This could result in
damage to the appliance.
socket 4 , press the blender release button 3
on both sides of the hand element q at
the same time. The blender e is now released
from the blender socket 4 .
from the blender socket 4 .
SHMS 300 C2