Wall Installation - THERMEx SUPER SILENT UDTRAEK Instrucciones De Montaje

38
THERMEX SUPER SILENT UDTRÆK

WALL INSTALLATION

The hood can be installed on the wall on with the brackets supplied. This is done by following the steps below:
1
x4
x2
Mount the brackets onto the motor box of the
hood. This is done by using the four screws
supplied.
4
x2
Pre-drill the holes and install rawlplugs intended
for the material into which they are installed.
7
Install the exhaust outlet on the hood. Take
care to ensure the non-return valve can open
and close freely.
NOTE: This only applies when venting into
open air.
2
Mount the spacer on the hood to close the gap
between the hood and the wall.
NOTE: The spacer can be used in two ways de-
pending on the distance to the wall.
5
Mount the hood on the wall using the two
screws supplied.
3
x2
Measure out the position of the holes for the
installation of the hood.
6
x4
Push the plugs into the four screw holes in the
hood.
M 520191251230102017