Installation Instructions - THERMEx Camino Eco Manual De Instrucciones

ENGLISH
GENERAL
Please read the contents of these instructions
carefully, as they contain important safety measures
regarding, installation, use and maintenance. (Please
save these instructions for future reference). The
appliance is designed to use an extraction function (air
exhaust to the outside - Fig.1B), with a filter
(recirculation of indoor air - Fig.1A) or external motor
(Fig.1C).
SAFETY SUGGESTIONS
1. Please note that if a hood and fireplace or chimney,
which use the air from the environment, are operating
simultaneously and not powered by electricity, the
hood will take the air that the fireplace or chimney
need for combustion from the environment.
negative pressure in the room should not exceed 4 Pa
(4x10-5 bar). There must be adequate ventilation in
the room to ensure safe use. External extraction must
comply with current national regulations.
Before connecting the model to a power supply:
Check the registration data (inside the hood)
-
to ensure that voltage and frequency match
the electricity
connection is appropriate. If you are not sure,
contact a qualified electrician.
If the power cord is damaged, please replace
-
it with a cable or a special wiring harness that
can be provided by the manufacturer or the
technical service provider.
Connect the appliance to the power supply
-
using a plug with a 3A fuse or to two cables in
a two-phase system protected by a 3A fuse.
2. Warning!
Household electrical appliances may be dangerous in
specific circumstances.
A. Never attempt to check the filters when the
hood is in use.
B. The lamps and the areas close to them
should not be touched during long periods of
use of the light installation or immediately
after.
C. Never cook food on open fire directly under
the hood.
D. Avoid using any kind of open flame as it may
damage the filters and present a fire hazard.
E. Always pay particular attention when frying
in order to avoid overheated oil igniting.
F. Always disconnect the power to the hood
before performing any maintenance.
network and that
G. Children or people who require supervision
must not use the hood.
H. Never allow children to play with the hood.
I. Ensure adequate ventilation when using the
hood simultaneously with appliances that
burn gas or other types of fuels.
J. Cleaning that is not carried out in accordance
with the instructions may present a fire
hazard.
This hood has been manufactured according to the
European Directive 2002/96 /EC on waste electrical
and electronic equipment (WEEE). The consumer
contributes to the prevention of negative effects on
the environment and health by ensuring that this
product is disposed of correctly.
The symbol
documentation indicates that this product should not
The
be treated as household waste but delivered to a
collection centre for the recycling of electrical and
electronic appliances. The product must be disposed
of in accordance with local waste disposal standards.
For more information about handling, collecting or
recycling this product, contact the local office
responsible, the collection point for household waste
disposal or the shop where the product was
purchased.
the

INSTALLATION INSTRUCTIONS

Qualified personnel should carry out all
-
installation and electrical connections.
Protective gloves should be worn for the
-
installation of the appliance.
Electrical installation:
The hood has been manufactured as a type 2
-
device and should therefore not be connected
to cable earth connections. There should be
easy access to the power socket, when the
hood is installed. A multi-cell switch between
the hood and the electricity network is
required to connect the hood if the cable has
no plug. There should be a gap of 3 mm
between the switches and the connection
must have the appropriate dimensions in
accordance with applicable standards.
Connection to electricity should be carried out
-
as follows:
The minimum distance between the top of the
cooking equipment and the bottom of the hood
should be at least 65 cm.
consisting of two or more parts should be used; the
on the product or the accompanying
o BROWN = L live
o BLUE = N neutral.
An interconnector