Installation - THERMEx PERPIGNAN Instrucciones De Montaje

58 THERMEX Perpignan

INSTALLATION

The range hood is available either with an internal motor or for installation with an external motor.
1
Measure out and mark the two "keyholes" on
the wall. NOTE: For a rear-facing exhaust
outlet, the holes are marked out in relation to
the exhaust outlet's position on wall
4
Hang the hood on the screws. Open the glass
door and remove the filter.
7
Re-hang the hood.
NOTE: For a rear-facing exhaust outlet, the
exhaust outlet should be installed on the hood
in this step.
2
x2
Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes.
5
Mark the position of the two lock-holes on the
wall and then remove the hood from the wall
once again.
8
x2
Reinstal the filter in the hood and close the
glass door.
3
x2
x2
NOTE: The screws must not be screwed in
further than the hood can be installed.
6
x2
Pre-drill the holes and insert the rawlplugs.
9
Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air and with the exhaust outlet facing
upwards.
M 536991350922122020
x2