Operating The Controls; For Best Results; Button Function - Faber Cylindra CYLN15SS600 Instrucciones De Instalación Información De Uso Y Cuidado

OPERATING THE CONTROLS

FOR BEST RESULTS

Start the Range Hood several minutes before cooking to develop proper
airflow. Allow the Range Hood to operate for several minutes after cooking
is complete to clear all smoke and odors from the kitchen.
Button Function
Turns the lights on/off at maximum strength.
Press and hold the button for approximately 2 seconds to turn the
Dimmer Lights On/Off.
L
Turns the motor on/off at speed one.
Turns the Motor on at speed two.
T1
Activated Charcoal Filter Alarm -
Press and hold the button for approximately 5 seconds, with all the
hood turned off (Motor and Lights), to turn the alarm on. The relevant
LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5
T2
seconds. The relevant LED flashes once.
Turns the Motor on at speed three.
Grease Filter Alarm and Charcoal Filter Alarm
To reset the alarm: press and hold the button for approximately 3
seconds, with the hood turned off (Motor and Lights), and until the
LED S1 flashes three times.
T3
S1
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the
system returns automatically to the speed that was set before. If it is
activated with the motor turned off, the hood will switch to OFF at the
end of the time.
T4
Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood
has been in operation for 100 working hours.
When this is activated, it signals:
S1
The Activated Charcoal Filter saturation alarm, indicating that the filter
must be changed;
The Metal Grease Filters must also be washed. The Activated Charcoal
Filter saturation alarm comes into operation after the Hood has been
working for 200 hours.
32
T1 T2
T2 T3
T3 T4
S1
T4
S1
T3 T4
T4
S1
Led
S1
-
-
ON
ON
ON
ON
ON
Flashing.