Remote Control Programming - Firman W03383 El Manual Del Propietario

120V, 30A RV (NEMA TT-30R) – Maximum full load
5
3
30 Amp current may be drawn from this 120 Volt receptacle. an AC circuit protector. If the generator is overloaded
Battery Power Restore Switch- Restore the battery or an external short circuit occurs, the circuit protector
4
6
power to the control module. You must press this will trip. If this occurs, disconnect all electrical loads and
switch and hold for 3 seconds before start the try to determine the cause of the problem before generator,
including recoil start, electric start attempting to use the generator again. If overloading and remote start.
causes the circuit protector to trip, reduce the load.
Output Ready Indicator Light – Remains "ON"
7
during normal operating conditions. Shuts "OFF" may cause damage to generator or equipment. The
when generator is overloaded. circuit protector may be reset by pushing the button
The green AC Power Indicator Light comes on
when the engine starts and generates power.
DC Circuit Breaker - The circuit protector may be
12
reset by pushing the button of the protector.
Parallel Operation Outlets - These outlets are used
13
for connecting two FIRMAN inverter generators for
parallel operation. A FIRMAN parallel kit(optional
equipment) is required for parallel operation.
12V DC outlet – 8.3 Amp of DC current may be drawn
14
from this receptacle.
Use this outlet to charge 12V automotive type
batteries ONLY. See 12V DC outlet (Battery Charger)
section.
Remote Start Program Button - Use this button
15
along with the remote control to program the
generator to be started remotely.
Remote Start Indicator light - The light will light or
16
flash depending on the status of the remote start
system.
Ground Terminal – Consult an electrician for local
17
grounding regulations.
Outlet Cover - Protect the receptacles from dust and
18
debris.
Fuel Valve Knob
19
Choke Button
20
Recoil Stater
21
12V DC Battery Charger Port - Plug the 120 Volt AC
22
charger into this port to charge the generator
battery.
Remote Holder - to hold remote control for easy
23
access.
English
Circuit Breakers – The receptacles are protected by
11
Note: Continuous tripping of the circuit protector
of the protector.
Page 08

Remote Control Programming

Before the generator can be started , an initial
start-up procedure must be performed so the
generator and the remote control recognize each
other.
NOTE:
YOUR REMOTE CONTROL IS ALREADY
PROGRAMMED IN
FACTORY FOR YOUR CONVENIENCE. AND IT IS
READY TO START THE GENERATOR.
If the remote control is replaced then you will need
to go through following procedure with new
remote control.
1. Flip the engine switch to the "RUN"(l) position.
2. Push the
power
switch
seconds
release.
battery
restore
for about 3
and then
Customer Service: 1-844-FIRMAN1