Add Engine Oil - Firman W03383 El Manual Del Propietario

Ocultar thumbs Ver también para W03383:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

temperatures ranging from -15°C (5°F) to 50°C (122°F) for short periods. If the product is exposed to
temperatures outside this range during storage, it should be brought back within this range before
operation. In any event, the product must always be operated outdoors, in a well-ventilated area and away
from doors, windows and other vents.
power.
Maximum wattage and current are subject to and limited by such factors as fuel BTU content ambient
temperature, altitude, engine condition and etc. Maximum power decreases about 3.5% for each
1,000 feet above sea level; and will also decrease about 1% for each 10°F(6°C) above 60°F(16°C)
ambient temperature.

Add Engine Oil

CAUTION
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil. Damage to the generator as
a result of failure to follow these instructions will void
NOTE:
your warranty.
The recommended oil type is 10W-30 automotive oil.
However outdoor temperatures will determine the
space proper oil viscosity for the engine. Use the
chart to select the best for the outdoor temperature
range expected.
Degrees Celsiusº(Outside)
Full Synthetic 5W-30
5W-30
Degrees Fahrenheitº(Outside)
1.Place generator on a flat and level surface.
2.Loosen the cover screw and remove the
maintenance cover.
3.Remove oil fill cap/dipstick .
4.Using oil funnel, slowly pour contents of provided
oil bottle into oil fill opening to the "H" mark on
dipstick. Be careful do not overfill. Overfilling with
oil could cause the engine to not start or hard
starting.
English
12
When operated above 77°F(25°C) there may be a decrease in
10W-40
10W-30
5.Replace oil fill cap/dipstick and fully tighten.
6.Reinstall maintenance cover and tighten screws.
7.Oil Level should be checked prior to each use or
at least 8 hours or operation. Keep oil level
maintained.
CAUTION
Customer Service: 1-844-FIRMAN1Page
Tabla de contenido

Solución de problemas

loading

Tabla de contenido