Firman W03383 El Manual Del Propietario página 17

*We are always working to improve our products. Therefore, the enclosed product may differ slightly
from the image on this page.
the starter motor(Electric start model only). To start when the generator is overloaded and will cut engine, press and
hold the switch in the "START"(ll) power to the receptacles.
position, the engine will crank and attempt to start. If the engine overload indicator light comes on, the When the
engine starts, release the switch to the generator's wattage / amperage capacity has been
"RUN"(l) position.
Economy Control Switch
2
The Economy Control switch can be activated in order to continue to run, but the red Engine Overload Indicator
minimize fuel consumption and noise while operating the
unit during times of reduced electrical output, allowing to connected electronic devices. the
engine speed to idle during periods of non-use. The
engine speed returns to normal when an electrical load is
connected. When the economy switch is off, the engine this light turns "ON". Engine will not run when runs at normal
speed continuously. indicator is lit.
1 Data-Minder(Multi-Meter) – Push the SELECT warning indicator light comes on and the engine button to show
the Voltage, Hertz and running hours. stops automatically. The engine will not start until 120V, 20A Duplex –
(NEMA 5-20R) 20 Amp of current the proper amount of oil is in the crank case. may be drawn from this 120 Volt
receptacle.
DC 5V 2.1A USB Outlet
10
English
Page 07
exceeded by connected electrical devices or by a
power surge. When this occurs, the green AC Power
Indicator Light(Item 7) will go off. The engine will
Light will stay on and power will no longer be supplied
Oil Warning Indicator Light – Check oil level when
9
When the oil falls below the minimum level, the oil 3-
Customer Service: 1-844-FIRMAN1