Remote Start; Remote Control Programming - Firman P03603 El Manual Del Propietario

Remote Start

This generator is equipped with a wireless remote
start system for starting and stopping.
The Remote Start functions are enabled when:
1.The Engine Switch is in the "RUN"(l) position, AND
2.The Battery Switch is in the "ON"(l) position.
The Remote Start functions are disabled if either
of the above conditions is not met.
Remote Control Power Consumption
While the Engine Switch is in the "RUN"(l)
position and Battery Switch is in the "ON"(l)
position, the remote module is active and
waiting for a remote signal. This function
requires electrical current from the battery.
If the Battery Switch is left in the "ON"(l)
position for extended periods (several weeks),
the battery can be completely drained.
NOTE:
THE BATTERY SWITCH ALWAYS SHOULD BE IN
"OFF"(O) POSITION AT THE END OF USE TO
PREVENT BATTERY DRAIN.

Remote Control Programming

Before the generator can be started , an initial
start-up procedure must be performed so the
generator and the remote control recognize
each other.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED IN
FACTORY FOR YOUR CONVENIENCE. AND IT IS READY TO
START THE GENERATOR.
If the remote control is replaced then you will
need to go through following procedure with
new remote control.
1. Flip the engine switch to the "RUN"(l) position.
English
2. Flip the battery switch to the "ON"(l) position.
3. Push and hold the program button on the
control panel for approximately 3 seconds. The
remote start indicator light will light.
Indicator
Light
Program Button
4. Push and release the ''STOP'' button on the
remote control. The indicator light will flash
once to erase the remote program.
STOP
5. Push and release the ''START'' button. The
indicator light will flash once to program the
remote.
6. Push and hold the program button approximately
3 seconds until the indicator light turn off. The
generator is now programmed to start remotely.
Page 12
START
Customer Service: 1-844-FIRMAN1