Firman W03383 El Manual Del Propietario página 33

8. Press and hold the engine switch in the
"START"(ll) position for few seconds and release
the switch to the "RUN"(l) position.
9. Push the
position.
"ON"(l)
to run at
each
engine
Generator (Remote Start)
6. Push the battery power restore switch for about 3 seconds and
release.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED IN
FACTORY FOR YOUR CONVENIENCE. AND IT IS READY TO START THE GENERATOR.
If the remote control is replaced, then you will need to go through programming procedure
in "Remote Control Programming" section.
1. Before starting the generator, check for loose 7. Push and release the ''START'' button on the
missing parts and for any damage which
may have occurred during shipment.
English
23
choke button to the
4. Turn the fuel valve to
position.
10. Allow
no load for fewminutes
initial start-up to permit
switch to the "RUN"(l)
engine and
generator
to stablize.
Starting
the
remote control. The generator will turn over for
3 to 5 seconds and start.
"RUN"
the
generator
upon
5. Flip the
position.
then
Customer Service: 1-844-FIRMAN1Page
or