Before First Use; Preparing The Product For Use - Silvercrest SZP 85 A1 Instrucciones De Utilización Y De Seguridad

before assembling or dismantling
the product, before cleaning the
product and during storms.
To prevent hazards, do not make
any alterations to the product.
CAUTION! RISK OF INJURY!
Do not directly touch the spinning
juicing cone ( and
2 a
or ). Do not hold a spoon or
2 b
similar on the spinning parts.
Keep long hair or loose clothing
away from spinning parts.
Only plug the mains plug into a
mains socket if the product is
completely assembled.
ATTENTION! RISK OF
PROPERTY DAMAGE!
Do not block and overload the
motor. Do not exert too much
pressure on the juicing cone
( and combined or
2 a 2 b
Make sure that there are no for-
eign objects in the sieve
the product when operating it.
To avoid damaging the product,
stop the juicing process immedi-
ately if the juicing cone (
combined or
2 b
spin easily or does not spin at
all. Unplug the mains plug and
check whether there are foreign
objects inside the product.
The product is equipped with an-
ti-slip rubber feet
combined
2 b
).
2 b
or
3
and
2 a
) does not
2 b
. As furniture
10
surfaces are coated with a variety
of varnishes and materials and
treated with different care products,
it cannot be ruled out that some
of these substances may contain
chemicals that will corrode and
soften the rubber feet
essary, place an anti-slip layer
under the product.
Place the product on a stable,
level surface.
Never place the product on hot
surfaces (i.e. hobs) or near sources
of heat or open fires.
Do not clean the base unit
the dishwasher or using boiling
water.
Do not use harsh or abrasive
cleaning agents.
FOOD SAFE! This prod-
uct has no adverse effect
on taste or smell.

Before first use

Preparing the product for use

Rinse the removable parts before the first use.
Use the cable winder
9
of the power cord that is not required and
11
fix this into the intended groove on the back of
the product.
Plug the mains plug into a mains socket.
Insert the drive shaft
6
bracket .
7
. If nec-
10
in
8
to wind up the length
into the drive shaft
GB/IE 17