Cleaning And Maintenance - Philips RESOIRONICS InnoSpire Essence Manual Del Usuario

Before performing any cleaning operation or filter replacement, disconnect the device
21
from the main supply by unplugging it.
Some parts are small enough to be swallowed by children. Do not let unattended children
22
have access to the unit.
If you no longer use the device, dispose of according to the local regulations in force.
23
Remember to:
24
• Use this device only with medications prescribed by your doctor;
• Use the accessories recommended by your doctor.
Instructions for use
Remove the compressor from carrying case if supplied before use.
After unpacking the device, check the compressor and accessories for visible damage or
1
defects such as cracks in the plastic housing which could expose electrical components.
Contact Philips Respironics customer service or your product distributor to report any
damaged product.
When taking a treatment, sit upright and relaxed.
2
Plug the compressor into the electrical outlet.
3
Refer to the nebulizer and accessory instructions for use before treatment.
4
To start the treatment, switch the device ON by pressing the ON / OFF switch onto
5
the "I" position.
When the treatment has been completed, switch the unit OFF by setting the switch
6
position to "O" and disconnect the plug from the electrical outlet.
This device is for intermittent use 30 min on/30 min off. Failure to operate
appropriately may lead to device damage.

Cleaning and maintenance

During cleaning, make sure the power cord is not plugged in the electrical outlet.
Cleaning of the compressor, nebulizer and accessories
Use a damp cloth to wipe down the outside of the compressor at least once a month. Refer to
nebulizer and accessory instructions for use for cleaning of the accessories and nebulizer.
Replacement of the nebulizer
The nebulizer and other accessories should be replaced according to its instructions.
6
Replacement of the filter
The filter is to be replaced when it appears discolored or wet.
Troubleshooting
The device does not turn on
• Make sure the plug is firmly fitted to the electrical outlet.
In the event of malfunction (insufficient pressure and flow) turn the unit off for 10 seconds
and turn back on.
After each cleaning, check that the unit is working properly by verifying that air still comes
out of the nozzle when the unit is turned to the "ON" position.
Unauthorized repair voids warranty.
If the device does not work properly after attempting these troubleshooting steps, contact your
authorized product distributor or Philips Respironics Customer Service at +1 724 387 4000.
Maintenance and repairs
Never open the device. There are no serviceable parts within the unit. The compressor
requires no lubrication or maintenance.
Technical specifications
Electricity supply 230 V/50 Hz, 1 Amp
Thermal overload protector Thermal fuse; functioning temperature 150 C°
Compressor max. pressure 317 kPa (3.17 bar)
Average flow rate 6 LPM @ 69 kPa (0.69 bar)
Max flow rate 8.0 LPM
Weight 1.5 kg
Size 165 x 165 x 108 mm
Noise level 58 ±3dBA
Technical specifications
Electricity supply 220 V/60 Hz, 1.2 Amp / 230 V/60 Hz, 1.2 Amp
Thermal overload protector Thermal fuse; functioning temperature 150 C°
Compressor max. pressure 296 kPa (2.96 bar)
Average flow rate 7 LPM @ 69 kPa (0.69 bar)
Max flow rate 9.3 LPM
Weight 1.5 kg
Size 165 x 165 x 108 mm
Noise level 58 ±3dBA
ENGLISH
7