General Information - Kong KES 2 Manual Del Usuario

CHAPTER

2 GENERAL INFORMATION

Users must read and perfectly understand
the information provided by the manufacturer
(hereinafter information)
the device. This information relates to
the characteristics, services, assembly,
disassembly, maintenance, conservation,
disinfection, etc of the device; even though
it does include some suggestions on how to
use the products, it must not be considered
as a true to life instruction manual.
WARNINGS
AND LIMITATION OF USE:
This device must be used only by physically
suitable people, trained (informed and
educated) to use it and in training activities, by
people under the direct control of instructors/
supervisors capable of guaranteeing their
safety.
- Do not use the device until you have read
this entire operating manual,
- before and after operation, all the checks
described in chapter 7.1 shall be carried
out. If the user has any doubt about the
efficiency of the device, it shall be replaced
immediately Improper use, deformation, falls,
wear, chemical contamination, exposure to
temperatures below -30°C or higher than
+50°C for the textile/plastic components/,
devices, and +100°C for metal devices, are
some examples of causes that may reduce,
limit or end the life of the device,
- this device can be used combined with
personal protective equipment that conforms
to Directive 89/686/EEC when compatible
with the relevant information from the
manufacturer,
6
2
- minimum resistance of anchoring points
shall be at least 12 kN,
- it is strictly forbidden to modify and/or repair
the device,
- avoid exposing the device to heat sources
or to contact with chemical substances.
Reduce direct exposure to sunlight to the
minimum necessary. At low temperatures
and in the presence of humidity, ice may form.
This, on textile devices, may reduce flexibility
and increase the risk of cuts and abrasions,
- make sure that the device has been
supplied complete, in its original packaging
and with the manufacturer's information. It
is compulsory for dealers selling products in
before using
countries other than the original destination
to check and supply the translation of this
information.
All our devices are tested/inspected piece
by piece in accordance with the procedures
of the Quality System certified according to
the UNI EN ISO 9001 standard. Our personal
protective equipment is certified by the
accredited authority indicated in the device's
specific instructions and, if they belong to
category III, are also subjected to production
surveillance - in compliance with article 11/B
of Directive 89/686/CEE - by an authority
whose accreditation number is indicated on
the device.
Original version in Italian dated 22/06/2017
Laboratory tests,
information and standards do not
always manage to reproduce what
actually happens in practice, and
so performance under real usage
conditions in a natural environment
can differ, sometimes
considerably. The best information
can be gained by continual practice
under the supervision of skilled,
expert, qualified individuals.
inspections,
even