General Information - Kong CONNECTORS Manual De Instrucciones

EN

1 - GENERAL INFORMATION

1.1) The information provided by the manufacturer
(hereinafter information) must be read and well
understood by the user before using the device.
1.2) All our devices are tested / checked piece by piece
in accordance to the procedures of the Quality System
certified according to the UNI EN ISO 9001 standard.
1.3) Personal protective equipment is certified by the
notified body reported in the specific instructions of the
device in accordance with Annex V of the Regulation
(EU) 2016/425. If Category III PPE, they are subject to
surveillance of production in accordance with Annex
VIII of the Regulation (EU) 2016/425 by the notified
body whose accreditation number is marked on the
device.
1.4) Personal use of the device to maintain continuously
is strongly recommended monitored the degree of
protection and efficiency.
1.5) Check that the device has been supplied intact,
in the original packaging and with its information. For
devices sold in different countries from the destination
of origin, the distributor shall verify and supply the
translation of this information.
1.6) This device can be used in combination with other
devices when compatible with relevant manufacturer
information.
1.7) Important
1.7.1) Avoid exposing the device to sources of heat
and contact with substances chemical. Reduce direct
exposure to the sun, in particular for textile and
plastic devices. Low temperatures and humidity can
facilitate the formation of ice, make it difficult to make
connections, reduce flexibility, as well as increasing the
risk of breakage, cutting and abrasion.
1.7.2) The position of the anchor is fundamental for
arresting a fall safely: carefully assess the clearance
under the user, the height of a potential fall, the stretch
of the line/rope, the deployment of an eventual energy
absorber, the height of the user, and the "pendulum"
effect, in order to avoid any possible obstacle (eg the
ground, the rubbing, abrasions, etc.).
1.7.3) The minimum strength of the anchor points shall
be at least 12 kN, both made on natural and artificial
elements. The evaluation of those made on natural
elements (rock, plants, etc.) are only possible in an
empirical way, so it shall be carried out by a trained
and experienced person. For those made on elements
artificial (metal, concrete, etc.), the evaluation can be
carried out scientifically, therefore it shall be carried out
by a trained and authorized person.
1.8) Warning
1.8.1) Prolonged suspension, especially if inert, can
cause damage irreversible and even death.
1.8.2) It is absolutely forbidden to modify and / or
repair the device, outside than what is prescribed