Package Contents; Electrical Safety - DeWalt DC411 Manual De Instrucciones

E NGLIS H
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack
NiMH, NiCd+ and Li-Ion.
Charges NiMH and NiCd
battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.

Package contents

The package contains:
1 Angle grinder
1 Type 27 guard
1 Side handle
1 Flange set
1 Two-pin spanner
2 Battery packs (DC411KL, DC411KB, DC411KA)
1 Battery charger (DC411KL, DC411KB, DC411KA)
1 Kit box (DC411KL, DC411KB, DC411KA)
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2, 8)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
44
INTENDED USE
Your DC411 grinder is designed for professional
grinding, wire-brush and cut-off applications. DO
NOT use under humid conditions or in presence of
flammable liquids or gases.
DO NOT use grinding wheels other than center
depressed wheels and flap-disc.
This heavy-duty angle grinder is a professional
power tool. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.
a. trigger switch
b. lock-off button
c. spindle lock button
d. spindle (fig. 8)
e. side handle
f. abrasive wheel
g. anti-lock up backing flange
h. threaded clamp nut
i. guard (type 27)
j. battery pack
k. battery release buttons

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains plug replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing
and you are competent to do this,
proceed as instructed below. If you are
in doubt, contact an authorized D
repair agent or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors
is dangerous if engaged in a live socket
outlet.
WALT E