GE 2-9120 Serie Guia Del Usuario

2-9120 /2-9130
Color Series
Telephone
User's Guide
2-9120 2-9130
2-9121 2-9131
2-9122 2-9133
2-9123 2-9134
2-9124 2-9136
2-9126 2-9137
2-9127
We bring good things to life.
FOLD
I I
NTERFERENCE NFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna (that is, the antenna for
radio or television that is "receiving" the interference).
• Reorient or relocate and increase the separation between the
telecommunications equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a
circuit different from that to which the receiving antenna is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
If these measures do not eliminate the interference, please consult your
dealer or an experienced radio/television technician for additional
suggestions. Also, the Federal Communications Commission has
prepared a helpful booklet, "How To Identify and Resolve Radio/TV
Interference Problems." This booklet is available from the U.S.
Government Printing Office, Washington, D.C. 20402. Please specify
stock number 004-000-00345-4 when ordering copies.
H A C
EARING ID OMPATIBILITY
This telephone system meets FCC standards for Hearing Aid
Compatibility.
FCC NUMBER IS LOCATED ON THE CABINET BOTTOM
REN NUMBER IS LOCATED ON THE CABINET BOTTOM
© 1998 Thomson Consumer Electronics, Inc.
2-9120/21/22/23/24/26/27
P.O. BOX 1976, Indianapolis, IN 46206
2-9130/31/33/34/36/37
Trademark(s) ® Registered
Marca(s) ® Registrada(s)
Printed in Philippines
2-9120/2-9130 Color Series (Folded size 80 x 158 mm)
FOLD
FCC R I
EGISTRATION
Your GE telephone equipment is registered with the Federal Communica-
tions Commission and is in compliance with parts 15 and 68, FCC Rules
and Regulations.
1 Notification to the Local Telephone Company
On the bottom of this equipment is a label indicating, among other
information, the FCC Registration number and Ringer Equivalence
Number (REN) for the equipment. You must, upon request, provide
this information to your telephone company.
The REN is useful in determining the number of devices you may
connect to your telephone line and still have all of these devices ring
when your telephone number is called. In most (but not all) areas, the
sum of the RENs of all devices connected to one line should not
exceed 5. To be certain of the number of devices you may connect to your
line as determined by the REN, you should contact your local telephone
company.
Notes
• This equipment may not be used on coin service provided by the
telephone company.
• Party lines are subject to state tariffs, and therefore, you may not
be able to use your own telephone equipment if you are on a party
line. Check with your local telephone company.
• Notice must be given to the telephone company upon permanent
disconnection of your telephone from your line.
2 Rights of the Telephone Company
Should your equipment cause trouble on your line which may harm
the telephone network, the telephone company shall, where
practicable, notify you that temporary discontinuance of service may
be required. Where prior notice is not practicable and the
circumstances warrant such action, the telephone company may
temporarily discontinue service immediately. In case of such
temporary discontinuance, the telephone company must: (1) promptly
notify you of such temporary discontinuance; (2) afford you the
opportunity to correct the situation; and (3) inform you of your right to
bring a complaint to the Commission pursuant to procedures set forth
in Subpart E of Part 68, FCC Rules and Regulations.
The telephone company may make changes in its communications
facilities, equipment, operations of procedures where such action is
required in the operation of its business and not inconsistent with
FCC Rules and Regulations. If these changes are expected to affect
the use or performance of your telephone equipment, the telephone
company must give you adequate notice, in writing, to allow you to
maintain uninterrupted service.
U
SING THE TELEPHONE FEATURES
A
UTOMATIC REDIAL
To automatically redial the last number you called:
1. Pick up the handset to get a dial tone.
2. Press REDIAL.
F
LASH
Press the FLASH button instead of the hook switch to activate custom calling services
such as call waiting or call transfer. Custom calling services are provided by the phone
company.
T T
EMPORARY ONE
If you have pulse service, you can temporarily change from pulse to tone service in order
to access services that require tone dialing (such as getting information from a local bank).
After dialing the telephone number, press and release the tone button, marked with an
asterisk (*). When you hang up, your phone returns to pulse service.
T T
ROUBLESHOOTING
Problem
No dial tone.
Won't dial out
Phone doesn't ring
Feedback when
dialing in PULSE mode.
Can't be heard by
other party
20909690 (Rev. 2 E/S)
98-08
20909690 (Rev. 1 E/S) • Sht 1 of 2 (4 Folds)
FOLD
M J
ODULAR ACK
NFORMATION
You need an RJ11 (CA11) type modular
jack, which is the most common type of
phone jack and might look like the one
pictured here. If you don't have a modular
jack, call your local phone company to
find out how to get one installed.
I
NSTALLATION
D
ESKTOP OR TABLETOP INSTALLATION
1
3
1. Remove telephone line cord from the pocket on the
bottom of the phone.
2. Run telephone line cord through the guides on the
bottom of the phone.
3. Connect the telephone line cord to a modular
telephone jack.
4. Slide the RINGER switch (on the side of the handset)
to ON.
5. Set PULSE/TONE switch (on the side of the handset)
to TONE for touch-tone service, or set it to PULSE for
rotary service.If you don't know which type of
service you have, check with the phone company.
IPS
Solution
• Check hook switch to make sure it pops up.
• Make sure PULSE/TONE is set to correct position.
• Make sure RINGER switch is set to ON.
• You might have too many phones on one line.
• This is normal. Power fluctuates with phone outpulsing.
• Make sure phone cord is securely plugged in.
• Make sure other phones aren't off the hook at the same time you're using the phone. It is
normal for the volume to drop when additional phones are used at the same time.
FOLD
R W
EQUIREMENTS ALL
1a. If the modular phone jack is in
the base plate on the wall
where you're going to mount
your phone, just plug the
telephone line cord into the
jack; mount the phone on the
posts; and set the RINGER
switch and PULSE/TONE
switch (described in detail
below).
2 1b. If the modular phone jack is
near the floor and you want
to mount the phone on the
wall, remove the telephone
line cord from the pocket that
is on the bottom of the phone.
Unscrew the circular cord
cover on the bottom of the
4
phone with a Philips screw-
driver. Wrap the phone cord
around the circular guide and
screw the circular cord cover
in place.
2. Plug telephone line cord into
the modular jack.
3. Slip mounting holes on the
bottom of the telephone over
the wall plate posts and slide
the base down until the
phone is firmly in place. (Wall
plate is not included.)
4. Slide the RINGER switch (on
the side of handset) to ON.
5. Set PULSE/TONE switch (on
the side of the handset) to
TONE for touch-tone service,
or set it to PULSE for rotary
service. If you don't know
which type of service you have,
check with the phone company.
L
IMITED
What your warranty covers:
• Any defect in materials or workmanship.
For how long after your purchase:
• One year. (The warranty period for rental units begins with the first
rental or 45 days from date of shipment to the rental firm, whichever
comes first.)
What we will do:
ABC DEF
1 2 3 • Provide you with a new or, at our option, a refurbished unit.
GHI JKL MNO • The exchange unit is under warranty for the remainder of the original
4 5 6
product's warranty period.
PQRS TUV WXYZ
How to make a warranty claim:
7 8 9
• Properly pack your unit. Include any cables, etc., which were
TONE OPER
originally provided with the product. We recommend using the original
0 #
*
carton and packing materials.
REDIAL
FLASH 0000 0000
• Include in the package evidence of purchase date such as the bill of
sale. Also print your name and address and a description of the defect.
Send standard UPS or its equivalent to:
REDIAL
Thomson Consumer Electronics, Inc.
button
Product Exchange Center
32 Spur Drive
FLASH
El Paso, Texas 79906
button
• Pay any charges billed to you by the Exchange Center for service not
covered by the warranty.
• Insure your shipment in case of loss or damage. Thomson accepts no
liability in case of damage or loss.
• A new or refurbished unit will be shipped to you prepaid freight.
What your warranty does not cover:
• Customer instruction. (Your Owner's Manual provides information
regarding operating instructions and user controls. For additional
information, ask your dealer.)
• Installation and set-up service adjustments.
• Batteries.
• Damage from misuse or neglect.
• Products which have been modified or incorporated into other
products.
• Products purchased or serviced outside the USA.
• Acts of God, such as but not limited to lightning damage.
Product Registration:
• Please complete and mail the Product Registration Card packed with
your unit. It will make it easier to contact you should it ever be
necessary. The return of the card is not required for warranty
coverage.
How state law relates to this warranty:
• This warranty gives you specific legal rights, and you may have other
rights which vary from state to state.
If you purchased your product outside the USA:
• This warranty does not apply. Contact your dealer for warranty
information.
M I
OUNT NSTALLATION
1a
2
3
1b
Mounting
holes
Screw-
driver
Screw
Coiled
handset
cord
Telephone
line cord
4
5
W
ARRANTY
FOLD