Install The Oven; Installation Instructions; Electrical Connections; Gas Connections - GE JGRP20 Instrucciones De Instalación

INSTALL THE OVEN

4

ELECTRICAL CONNECTIONS

An adequate electrical supply and outlet must be used
to operate the electrical parts of your oven.
A. The oven cord has a three-prong plug and must be
used with a properly grounded three-hole outlet with
a standard 120 Volt, 60 cycle AC household current.
B. Install the electrical outlet below the oven on the left
side, in a location that is easily reached through the
C. If you do not have a three-hole grounded outlet,
have a qualified electrician change your old one.
D. A grounding adaptor will be needed to convert the
old one until the outlet can be replaced. This method
is only temporary, and a qualified electrician should
test it to be sure it meets requirements.
Always unplug the oven cord before making any
electrical repairs to the oven. When unplugging the
oven, always grasp the plug, never the cord.
WARNING
NEVER USE AN EXTENSION CORD
TO CONNECT THE OVEN TO THE ELECTRICAL
SUPPLY.
WARNING
Do not under any circumstances
cut or remove grounding prong from oven cord.
Failure to provide proper polarization may create a
hazardous condition.
Plug with ground prong
properly polarized and
grounded receptacle.
N
Preferred Method
Fig. 4
4

Installation Instructions

Polarized receptacle
properly grounded.
Metal Eyelet
Ground
L
Receptacle Plate
Mounting Screw
Temporary Method
Fig. 5
5

GAS CONNECTIONS

WARNING
Do not operate the burners of
this oven when using LP (bottled) gas before
converting the pressure regulator and burner
orifice for LP gas usage.
See page 2 for all gas requirements.
A. Shut off the gas supply at the shut-off valve.
B.
C. Discard any old or used connectors.
WARNING
Never reuse old flexible
connectors. The use of old flexible connectors can
cause gas leaks and personal injury. Always use
new connectors when installing a gas appliance.
D. Be sure no strain has been placed on the
connecting line assembly.
To prevent any leaks, use a pipe joint compound
that resists the action of LP gas on the male outside
threads.
E.
F.
front surface of the cabinet.
13-1/2"
22"
to
28"
Recommended Main Shut-Off Location
(The regulator also has a shut-off lever)
G. Install a shut-off valve to the pipe.
H. Remove the storage drawer and the oven door.
22"
8-1/2"
Min.
9-5/8"
Max.
Fig. 6
31-2000792 Rev. 0