Safety Notes - Scheppach Basa 1.0 Traducción De La Instrucción De Original

Idle running L
pAeq
Operation L
pAeq
the mentioned emission values.
In these operating instructions we have marked the
places that have to do with your safety with this sign.

Safety notes

who work on this machine.
Personnel entrusted with work on the machine
must have read the operating instructions and in
particular the chapter on safety before beginning
gun, is too late. This applies especially to persons
working only occasionally on the rnachine, e.g.
during setting up or rnaintenance.
the machine.
to the machine are complete and perfectly legible.
lines.
ground.
around the machine.
hands from the rotating tool.
and covers must be mounted, and the door protecting
the saw blade must be closed.
your working area and the machine connected to the
mains as well as from the supply lines.
while it is not in use.
formance range according to the technical specifications
contained in the operating instructions.
in an upright position, and wear shoes with an anti-slip
sole.
tended for. Protect it from heat, oil, and sharp edges.
more effective and safe.
and grease.
been removed before you turn the machine on.
sion cables that are identified accordingly.
your working area and the machine connected to the
mains as well as from the supply lines.
ing. Perform your work sensibly. Do not use the device
when you cannot concentrate.
and covers must be mounted.
nected to the power supply.
and waste wood. Disorder in the working area may result
in accidents.
may not injure themselves at the standing machine or
may put the machine into operation. Please make sure
that the machine is not standing outside without any
protection or is in a humid environment.
sion.
- Trainees must be at least 16 years of age, but may only
operate the machine under adult supervision.
from their work.
and wood scrap.
and other jewelry.
protection mask while you are working with the ma-
chine.
from rough materials.
chine.
moved or rendered unusable.
X
machine may only be carried out when the motor is
switched off. Pull the power supply plug and wait
for the rotating tool to completely stop.
-
may be carried out by a qualified electrican only.
completing repair and maintenance procedures.
X
Switch the machine off and pull power supply plug
- when rectifying any malfunctions.
dust. The current speed at the suction connection piece
before starting up.
tered form.
-
stop you must use a sliding stick.
between the parallel limit stop and the saw blade is less
-
rear of the machine.
placed.
-
port to prevent the work piece from turning.
does not turn.
-
-
-
-
-
-
-
-
english 11