Stryker IsoAir Manual De Operación página 26

2. To unlock the screen, press and hold the A A c c t t i i o o n n button next to the L L o o c c k k e e d d icon for two seconds (Figure 22).
P P o o w w e e r r i i n n g g o o f f f f t t h h e e p p u u m m p p
Press the P P o o w w e e r r button and hold for two seconds to power off the pump.
S S t t o o r r i i n n g g t t h h e e s s u u p p p p o o r r t t s s u u r r f f a a c c e e
C C A A U U T T I I O O N N - - Always store the product within the specified environmental condition values.
To store the support surface:
1. Start Max Inflate, see Starting or canceling Max Inflate (page 16).
2. Clean and dry the product.
3. Power off the pump.
4. Press the tab in on the CPR connector to disconnect.
5. Remove the CPR connector from the pump.
6. Deflate the support surface.
7. Roll the support surface from the head end to the foot end of the bed.
N N o o t t e e - - Make sure that you insert the AST cable and hose when you roll the support surface.
8. Use the straps on the bottom center to tie the rolled support surface.
N N o o t t e e - - Use the foot end handles to lift and move the support surface for storage.
9. Follow your hospital protocols to store the product.
EN 22
F F i i g g u u r r e e 2 2 1 1 – – U U n n l l o o c c k k e e d d s s c c r r e e e e n n
F F i i g g u u r r e e 2 2 2 2 – – L L o o c c k k e e d d s s c c r r e e e e n n
2941-009-005 Rev A.0