Stryker IsoAir Manual De Operación página 18

• Always check the power cord for cuts, exposed wires, worn insulation, or other damage that could result in electrical
hazards.
To setup the pump:
1. Bring the product to room temperature.
2. Place the pump in a secure location. Allow space around the pump to connect and disconnect the hoses and power
cord. Optional placements:
a. Option 1: Hang the pump on a compatible bed. Make sure that the pump is secure.
b. Option 2: Place the pump on the floor. Make sure that the pump is away from foot traffic to avoid the risk of a trip
hazard.
3. Connect the AST cable.
4. Connect the hose.
C C o o n n n n e e c c t t i i n n g g t t h h e e p p o o w w e e r r c c o o r r d d
W W A A R R N N I I N N G G - - Always plug the power cord into the bed auxiliary outlet or a grounded power respectable. Do not use an
extension cord.
To connect the power cord:
1. Attach the power cord to the pump.
2. Plug in the power cord into an accessible outlet.
3. Place the power cord out of the path of foot traffic to avoid trip hazards.
A A p p p p l l y y i i n n g g l l i i n n e e n n s s
To apply linens:
1. Part the D-rings (C) (Figure 2).
2. Thread the four linen corners through the D-rings (C) attached to the bottom cover to secure the linens (A) to the support
surface (B).
N N o o t t e e - - This product is designed for use with non-fitted sheets. For best results, do not pull the linens too tight to avoid the
hammock effect.
EN 14
A
C
B
F F i i g g u u r r e e 2 2 – – A A p p p p l l y y l l i i n n e e n n s s
2941-009-005 Rev A.0