Operating Instructions; Warnings; Starting The Appliance - Nordcap GRK9 Manual Del Usuario

Sparker plug (Fig. 6 "1")
• Remove the front panels.
• Disconnect the cable from the plug.
• Unscrew lock nut "6".
• Replace the component and reassemble according
to the opposite sequence.
Thermocouple (Fig. 6 "2" and Fig. 5)
• Remove the knobs, control board and front panel.
• Unscrew the screws "7" from the pilot set and "3"
of gas valve.
• Replace the component and fasten it again with
suitable hose clamps.
• Reassemble the components and the panels
according to the opposite sequence.
Pilot burner (Fig. 6 "3")
• Remove the front panel.
• Unscrew and remove thermocouple "2", gas
connector "4" and sparker plug "1".
• Remove nozzle "5" and store it. Disassemble
pilot burner "3" and replace with the new one.
• Reassemble the whole unit according to the
opposite sequence of disassembling operations.
• Check the tightness.
Main burner (Fig. 7)
• Remove the front panel and the protection
closing the combustion chamber.
• Disconnect
the
connector "E" down to the solenoid valve.
• Remove the screws fastening the burner set onto
its own support and extract it from the casing.
• When installing the burner, carry out the same
operations in opposite sequence.
• Before reassembling the panels check the
tightness.
II - OPERATING INSTRUCTIONS
This appliance has been designed to cook food in
aqueous medium and it must be used exclusively
by skilled personnel
operating instructions. Any other illegitimate use is
dangerous.

1 - WARNINGS

• Read these operating instructions carefully because
they give important information about the safety of
installation, use and maintenance.
• Keep this handbook with care so that it can be
consulted in any time.
• The installation of this equipment and its possible
adaptation to other types of gas must be performed
exclusively by skilled personnel.
• For any repair refer to the nearest after-sales
centre authorized by the manufacturer and require
supply pipe unscrewing
complying with
Gas valve (Fig. 5)
• Remove the knobs and the control board.
• Unscrew the pipe of pilot burner "2" and of
thermocouple "3".
• Unscrew gas inlet and outlet connectors "4" and
"5".
• Remove the screws fastening the valve onto its
own support.
• Replace the component reassembling according to
the opposite sequence.
• Before reassembling the panels check the
tightness.
Pressure switch, gas solenoid valve
• Remove the knobs, the control panel and the
front panel.
• Replace the component reassembling according to
the opposite sequence.
• Before reassembling the panels check the
tightness.
Drain cock
• Unscrew the lock nut carefully with the specific
key.
• Take care not to damage the chrome plating and
not to unscrew the hose for the connection with
the tank.
• Before reassembling, replace the gasket, if
necessary.
original spare parts exclusively.
Not complying with this instruction will compromise the
these safety of the
manufacturer's warranty.
2 – STARTING THE APPLIANCE (Pages 5 and 6)
• Before setting the appliance at work, wash the
cooker inside with hot water and detergent, then
rinse out with plenty of water.
• Our appliances offer high performance. Do not use
the appliance without load nor in conditions
compromising its optimum performance (with open
doors or lids, for instance) in order to reduce the
consumptions of electric power, water or gas.
• When possible, pre-heat the equipment only before
use.
22
DOC. NO. 5958 9AY00
Edition 1
equipment and invalidate
- 01.2013
the