Airzone ACUAZONE IBPRO32 Guía De Instalación Rápida página 30

Once configured, perform the connection with the radiant elements to control per each relay output of the module.
ES
Important: The Airzone system is not compatible with electric duct heaters, it may result in system malfunction and/or fire.
EN
4.- Connection to the ducted unit
FR
- Through gateway: Connect the communication gateway to the AC unit port of the main control board
connect it to ducted unit, follow the instructions of the communication gateway sheet. It is recommended to install
IT
the thermostat of the unit. For the connection of DIN rail gateways, use (2x0.22 mm
on the connector of the main control board.
PT
DE
- Through Start-Stop: Use the main control board relay
manufacturer's instructions. I
5.- Connection of the zone modules with the elements/systems to control (Fancoil, Split, etc.)
You can find the instructions on how to connect these elements to the control modules on their data sheets.
6.- Connecting the thermostats
Connect each thermostat to the terminal corresponding to its zone module. Use (2x0.5+2x0.22 mm
In case of Wireless element, check it has the battery on.
30
Control relay specs: Imax = 10 A at 110/230 V, voltage-free.
Note that to control elements with a greater power, it is recommended to use contactors in accordance
with the power required. Remember to connect the neutral connector directly from the circuit to the
element to be controlled.
1 A, V
max max
Controller
to perform the start-stop of the unit following the
24 / 48 Vdc.
Terminals of zone module
. In order to
2 ) Airzone wire. Use the shield only
) Airzone wire.
2