Maintenance/Cleaning; Cleaning; Service Intervals; Service Intervals Table - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

GB IE

Maintenance/Cleaning

Warning! Risk of injury by
dangerous moving parts!
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Remove the rechargeable battery
from the device before cleaning
and maintenance.
Wear gloves when working with the
blade, saw chain and cutter bar.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that the screws
are fi rmly in place.
• Do not cut with blunt or worn blades or
chains as otherwise you will overload
the motor and gears of your device.
• Check coverings and safety devices for
damage and correct seating. Replace
these where necessary.

Service intervals table

Machine part Action
Complete ma- Check condition, replace damaged
chine parts as needed
Accessible
Tighten
screws and nuts
Chain wheel Check, replace as needed
Check, apply oil, reground or replace 
Saw chain
Blade bar Check, rotate, clean, apply oil
Cutter head Check correct installation
Gears lubricating
66

Cleaning

Remove the rechargeable battery
from the device before cleaning.
• Clean the appliance after each use. Cle-
an the motor housing with a damp cloth
or a brush. The device must neither be
sprayed with water nor be put into water.
• Keep the ventilation channels of the de-
vice clean. Use a damp cloth or brush
to do this.
• Do not use any cleaning agents or
solvents. This could damage the device
irreparably. Chemical substances may
attack the plastic parts of the device.
• Always keep the device clean. After
each use of the device, you must
- clean the blade
(with an oily cloth);
- oil the cutter bar with
an oil can/spray.

Service intervals

Carefully perform the maintenance tasks
listed in the following table on a regular
basis. Regular servicing of your unit will
extend the life of your equipment.
Additionally, you will achieve optimum cut-
ting performance and prevent accidents.
Before each use After 10 hrs of use






