Maintenance And Cleaning; Disposal - Parkside PDSP 1000 E6 Manual Del Usuario

Fault/possible cause Remedy
Blocked sand­blasting
material pipes
Sand-blasting pattern not as expected
The air is not dry
enough .
Sand­blasting material
grain size not uniform
Sand­blasting material
impure
The attachment is worn Replace the attachment
Other defects
Please contact an expert or your retailer .

Maintenance and cleaning

WARNING! RISK OF INJURY!
ALWAYS disconnect the appliance
from the compressed air supply
before cleaning it.
■ Always clean the compressed air sandblaster
gun and the blasting medium container
immediately after completing your work . To do
this, blow out the compressed air sandblaster
gun and the blasting medium container
with compressed air .
■ Store the compressed air sandblaster gun
only in dry rooms .
PDSP 1000 E6
Check that no lumps of
sandblasting material
are blocking the pipes .
Preferably, use a blow­
out gun to clean
blocked pipes .
(Wear safety
goggles!) Also check
the tank outlet opening .
Install a water separator
in your compressed air
system .
Replace sand­blasting
material .
Replace sand­blasting
material

Disposal

The packaging is made from environ­
mentally friendly material and can be
disposed of at your local recycling
plant .
Do not dispose of the appliance in
the normal domestic waste!
Your local community or municipal
authorities can provide information on
how to dispose of the worn­out appli­
ance .
Dispose of the packaging in an environ­
mentally friendly manner . Note the
labelling on the packaging and sepa­
rate the packaging material compo­
nents for disposal if necessary . The packaging
material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites .
Your local community or municipal
authorities can provide information
on how to dispose of the worn­out
product .
GB │ MT │ 37 ■