Brush Cutter - Kickback Causes And How To Avoid Them With A 3-Tooth Blade; Additional Safety Instructions - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

g) Be careful to avoid injuries
to your feet and hands by
the cutting unit.
h) Make sure to keep the ven-
tilation openings free of for-
eign objects.
i) Never replace a non-metallic
cutting unit with a metallic
cutting unit.
j) Avoid an abnormal body
posture, keep your balance
at all times and ensure secu-
re footing on slopes.
Walk when holding the device
in your hand. Do not run!
k) Never operate the machine
with defective guards or
covers or without protection
or without guards.
l) Warning! Ensure that you
do not touch any of the dan-
gerous moving parts before
you have removed the re-
chargeable battery and that
the dangerous moving parts
have come to a complete
standstill.
Maintenance and storage
a) Always disconnect the machi-
ne from the power supply (i.e.
remove the removable battery)
before performing maintenance
or cleaning.
b) Only use spare and accessory
parts recommended by the ma-
nufacturer.
c) Regularly inspect and maintain
the machine. Only have main-
tenance performed by a con-
tract workshop.
d) When the machine is not being
used, store it out of the reach of
children.
Brush cutter - kickback
causes and how to avoid
them with a 3-tooth blade
In the event of a kick-
back, the operator will
feel a powerful blow
from the combination
machine. This may lead
to losing control of the
device and serious inju-
ry. You can avoid kick-
backs through caution
and proper technique.
While working with the 3- tooth
blade there is a risk of kickback
if the blade edge hits an obstacle
(stone, wood).
• Hold the device with both hands.
• Make sure there are no obstacles
on the ground and do not use the
3-tooth blade near fences, metal
posts or similar.
Additional safety
instructions
• Hold the power tool only by the
insulated gripping surfaces as
the cutting blade may come into
contact with concealed power
lines. Contact with a live wire
can also cause a charge in me-
tal parts of the appliance and
result in an electric shock.
• Carefully inspect the surface to
be cut, and remove all wires
GB IE
Use only properly
sharpened tools.
To cut thick stems,
switch the device
to position A.
55