Operation; Mount The Collecting Bag For Sandblasting Material; Select And Fitting Attachments; Filling The Blasting Medium Container - Parkside PDSP 1000 E6 Manual Del Usuario

Operation

Mount the collecting bag
for sandblasting material
■ Use a screwdriver to attach the collecting
bag to the appliance with the supplied
screw clip .

Select and fitting attachments

■ Start by selecting the appropriate attachment
for the job at hand ( ,
■ Push the selected attachment firmly onto the jet
nozzle , ensuring that no air can escape from
the sides .

Filling the blasting medium container

CAUTION!
► Before you open the screw cap
blasting medium container
other settings, the connection to the
compressed air hose must be disconnected
and all pressure completely discharged .
■ Use only suitable blasting media
sandblasting work .
NOTE
► We recommend using a blasting medium
(ground blast furnace slag) with a grain size
of 0 .2–0 .8 mm and which has been shown
not to cause silicosis .
■ Please ensure that the blasting medium
totally dry and not too coarse­grained .
NOTE
► The maximum grain size is 0 .8 mm .
■ Open the screw cap
container by turning it anticlockwise .
■ Fill the required amount of blasting medium
into the blasting medium container
■ Ensure that you do not exceed the maximum
fill level for the container of 900 ml .
■ Afterwards, close the screw cap
blasting medium container
clockwise .
PDSP 1000 E6
, , ) .
on the
, or make any
for your
is
on the blasting medium
.
on the
by turning it
NOTE REGARDING THE BLASTING
MEDIUM GRAIN SIZE
► The larger/coarser the grain size of the
blasting medium used, the coarser the dirt
that can be removed using it . The supplied
material, on the other hand, is fine and thus
more suitable for the removal of items such as
paint or rust film . The fine material also
causes less damage to the surfaces being
treated, meaning a choice can be made
regarding these .
For coarse rust, for example, it is best to use a
coarser­grained blasting medium which you
can buy online (see section "Importer") or in
any good specialist retailer . Please observe
the guidelines regarding maximum grain size .
Connecting the compressed air
supply
NOTE
► The compressed air sandblaster gun
only be operated on cleaned, condensate­
and oil­free compressed air and may not
exceed the maximum operating pressure of
6 .3 bar at the appliance .
To ensure that you can regulate the air pres­
sure, the compressed air source should be
equipped with a (filter) pressure reducer .
♦ Connect the compressed air sandblaster gun
to a suitable compressed air source by attaching
the quick­connect coupling on the supply hose
to the nipple on the sandblaster gun
The connection locks automatically .
NOTE
► Ensure that the control dial
before connecting the appliance to the
compressed air source .
may
.
is set to
GB │ MT │ 35 ■