Overload Switch Has Triggered - Speck pumpen BADU Jet perla Manual De Instrucciones

8 Malfunctions
Problem
No water jet despite the
unit being turned on.
8.1.1

Overload switch has triggered.

If the built-in or external overload switch triggers, implement the follow-
ing steps:

Motor shaft not running smoothly:

Motor shaft runs smoothly:

If the pump has seized, repeated starting can damage the motor.

56 EN VG 766.2330.061
Separate the unit from the power supply.
– Turn the motor shaft on the fan side with a screwdriver and
check that it is running smoothly.
Remove screwdriver.
– Notify customer services and have the overhang counter swim
unit inspected.
Remove screwdriver.
– Reconnect the power supply.
Only switch the unit on once.
– Wait until the motor has cooled and only then reset the over-
load switch
– Have an electrician check the power supply, safeguards and
power consumption.
– If the built-in or external overload switch trips again, notify cus-
tomer services.
Possible Cau- Possible solution
se
- Air in the sys-

tem
- Leakage in the

suction line
- Air drain valve
leaking or not
closed
Check screws, re-
place seals.
Ventilate the pump
and suction line.
See point 6.1,
page 51
05/2013