Led Channel Learning - Nice Patio Control Instrucciones Y Advertencias Para La Instalación Y El Uso

5.4 LED CHANNEL LEARNING

11
To perform LED channel learning:
on selector [S1]: switch off the receiver (1 = OFF; 2 =
1.
OFF)
on the channel selector: select the first channel to be
2.
programmed and set the switch to "ON" (switches 1 to 4)
on the remote transmitter: press button [PRG] for 1 sec-
3.
ond; LED "L1" (red) will flash twice
on the remote transmitter: press button [STOP
4.
seconds; LED "L1" (red) will flash 4 times
on the remote transmitter: press buttons [OPEN
5.
[CLOSE ] simultaneously for 5 seconds; the program-
q
ming of the first channel is complete
repeat the procedure to program the remaining three
6.
channels.
To set option 1 or option 2:
on the remote transmitter: press button [PRG] for 1 sec-
1.
ond; LED "L1" (red) will flash twice
S1
] for 5
o
] and
p
2. on the remote transmitter, choose the desired option as
follows:
– Option A: press button [OPEN
"L1" (red) will flash 3 times
– Option B: press button [CLOSE
"L1" (red) will flash 4 times.
To perform LED channel check:
on the channel selector: set switch 5 to "ON"
1.
2.
on the channel selector: keeping switch 5 active, set
switch 1 to "ON" and check that the LED connected to
this channel switches on correctly
on the channel selector: carry out the same operation for
3.
the remaining channels (switches 2,3,4).
a
In the event that the LED channel learning was not
completed successfully, repeat the learning proce-
dure.
] for 5 seconds; LED
p
] for 5 seconds; LED
q
ENGLISH – 15