Tabla de contenido
General Purpose Controllers 5–8
status
2nd byte
3rd byte
BnH
50-53H
vvH
Portamento Control
status
2nd byte
3rd byte
BnH
54H
kkH
kk = Source Note Number: 00H - 7FH (C-1 - G9)
* This is transmitted when ARPEGGIATOR/RPS [ON] is turned on, ARPEGGIATOR / RPS [MODE] is set to UP/DOWN/UP&DOWN/RND, Arp Beat Pattern is set to PORTA-A1 -
PORTA-B15 and you play an arpeggio.
Effects Depth 2-5
status
2nd byte
3rd byte
BnH
5C-5FH
kkH
Program Change
status
2nd byte
CnH
ppH
pp=Program number: 00H - 7FH (prog.1 - prog.128)
* This is transmitted when Tx/Rx ProgChg ([MIDI]) is PC or BANK SEL + PC.
* This is transmitted on the Perform Ctrl CH ([MIDI]) when a performance is changed, and on the Part MIDI CH ([PART]) of that part when a patch is changed.
Channel Pressure
status
2nd byte
DnH
vvH
* When Tx/Rx Edit SW ([MIDI]) is ON and Tx/Rx Edit Mode ([MIDI]) is set to MODE2, the Tx/Rx Setting ([MIDI]) setting will be valid. In this case when AFTERTOUCH is assigned to a
controller (slider or knob), operating that controller will transmit Channel Pressure messages on the Part MIDI CH ([PART]) of that part. With the factory settings, AFTERTOUCH is not
assigned to controllers.
* When Control Up/Control Down ([MIDI]) is assigned to AFTERTOUCH, settings of
VOICE MODULATOR [ON]
Vocal Morph Ctrl
Vocal Morph Sens
VocalMorph Thrsh
will mean that when audio is input to VOCAL/UPPER, Channel Pressure messages will be transmitted on the Part MIDI CH of the part specified by PANEL SELECT (when KEY MODE is
SINGLE or SPLIT) or of both Upper and Lower parts regardless of PANEL SELECT (when KEY MODE is DUAL). With the factory settings, AFTERTOUCH is assigned to Control Up.
Pitch Bend Change
status
2nd byte
3rd byte
EnH
llH
mmH
mm,ll=Pitch Bend value:
00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
* When performance parameters are set as follows,
VOICE MODULATOR [ON]
Vocal Morph Ctrl
Vocal Morph Sens
VocalMorph Thrsh
and Morph Bend Assgn is also turned ON, inputting audio to VOCAL/UPPER will cause Pitch Bend Change messages to be transmitted on the Part MIDI CH of the part specified by
PANEL SELECT (when KEY MODE is SINGLE or SPLIT) or of both Upper and Lower parts regardless of PANEL SELECT (when KEY MODE is DUAL).
System Realtime messages
Active Sensing
status
FEH
* This is transmitted at intervals of approximately 200 msec.
202
(Controller number 80–83)
(Controller number 84)
(Controller number 92–95)
ON
ON
1 - 63
0 - 126
ON
ON
other than 0
other than 127
Tabla de contenido
