Control Change - Roland JP-8080 Manual Del Usuario

196
* For details on the address, size, and checksum values, refer to ÒExamples of exclusive
messages and calculating the checksumÓ (p.206).
* Data whose size is greater than 256 bytes should be divided into packets of 256 bytes
or less and transmitted. Successive ÒData Set 1 messages should have at least 20 ms of
time interval between them.
Identity Request
status data byte
F0H 7EH, dev, 06H, 01H
F0H Exclusive status
7EH ID number
dev device ID
06H Sub ID#1
01H Sub ID#2
F7H EOX
* ÒdevÓ matches the unitÕs own device ID, or is 7FH (Broadcast).
* Even if an identity request message is received with a setting of Broadcast, the reply
will be sent using the unitÕs own device ID.
2. MIDI messages received at Remote
Keyboard In
Channel voice messages
Note Off
status 2nd byte 3rd byte
8nH kkH vvH
9nH kkH 00H
* This is received only when Remote KBD CH ([MIDI]) is ALL or when the MIDI
channel of the note-off matches.
* Note-off messages that are received will turn off notes of the part according to the
PANEL SELECT and KEY MODE settings. At the same time, a note-off message will be
transmitted from MIDI OUT on the Part MIDI CH ([PART]) of that part.
* If ARPEGGIATOR/RPS [ON] is on, the received note-off messages can control the
arpeggiator or RPS.
* If the Indv Trig Switch ([PFM COMMON]) is ON and KEY MODE is SPLIT, received
note-off messages that are below the Split Point ([PFM COMMON]) will release the
envelope specified by Indv Trig Dest ([PFM COMMON]).
Note On
status 2nd byte 3rd byte
9nH kkH vvH
* Received only when Remote KBD CH ([MIDI]) is ALL or when the MIDI channel of
the note-on message matches.
* Note-on messages that are received will sound notes on the part according to the
PANEL SELECT and KEY MODE settings. At the same time, a note-on message will be
transmitted from MIDI OUT on the Part MIDI CH ([PART]) of that part.
* When ARPEGGIATOR/RPS [ON] is on, received note-on messages can control the
arpeggiator or RPS.
* When Indv Trig Switch ([PFM COMMON]) is ON and KEY MODE is SPLIT, received
note-on messages that are below the Split Point ([PFM COMMON]) will start the
envelope specified by Indv Trig Dest ([PFM COMMON]).

Control Change

* Received only when Remote KBD CH ([MIDI]) is ALL or when the MIDI channel of
the control change matches.
* If Control Up/Control Down ([MIDI]) is set to control change, this message will
function as controller up or down for the part specified by PANEL SELECT (when
KEY MODE is SINGLE or SPLIT) or for both the Upper and Lower parts regardless of
PANEL SELECT (when KEY MODE is DUAL). At the same time, a control change
message will be transmitted from MIDI OUT on the Part MIDI CH ([PART]) of that
part.
status
F7H
(Universal Non-Realtime Messages)
(dev: 10H-1FH (1-32) or 7FH (Broadcast), default
value is 10H (17))
(General Information)
(Identity Request)
(End Of Exclusive)