Pulsar FORWARD F455S Manual Del Usuario página 8

IR Illuminator
•
Remove the cap (12) from the
connector to attach the IR
illuminator (13).
•
Remove the cover (11) from the
IR illuminator.
•
Mount the IR illuminator on the
device. The lever (25) should be
in the up position.
•
Lock the IR illuminator by
pressing the lever (25) down.
•
Make sure that the IR
illuminator is mounted and connected to the device.
•
Turn on the device using the ON (9) button to activate the IR illuminator.
•
The status bar will display a disabled illuminator icon if the IR illuminator
is not connected. This icon is not displayed when the IR illuminator is
connected.
•
Briefly press the IR (24) button at the end of the illuminator. The power level
when switching on is minimum
•
The IR illuminator icon will be displayed on the status bar with the relevant
power level.
•
Successive brief presses of the IR (24) button will toggle the brightness level
of the illuminator (
•
To adjust the position of the light spot in the field of view of the device, turn
the IR-illuminator lens lock knob (26) to the OPEN position.
•
By moving the lens of the IR illuminator with your hand, adjust the required
position of the light spot in the field of view of your device. After successful
adjustment, turn the lock knob (26) in the CLOSE direction while aiming the
lens in the desired direction to lock the IR illuminator lens.
•
The IR illuminator is turned off by a long press of the IR (24) button.
•
The IR icon will disappear from the screen.
Mounting Attachment On Riflescope
•
Select the adapter (available separately) with the required diameter of insert
depending on the outer diameter of the lens of your optical riflescope (see
the Table).
•
The designation 42mm / 50mm / 56mm in the title of the adapter refers to
the optical diameter of the lens in the optical riflescope.
•
Remove the cap (16) from the 42mm adapter (19) (#79171) by turning it
clockwise. To remove the cap from the 50mm (#79172) or 56mm (#79173)
adapters, turn it anticlockwise.
•
Degreasing of the body of the optical riflescope before mounting is
recommended.
•
Mount the insert (18) onto the adapter (19) as far as it will go.
•
Move the lever (22) to the OPEN position.
• Mount the adapter with the insert into the lens of the optical riflescope (17).
•
Move the lever (22) from its initial OPEN position to the CLOSE position.
•
Ensure that the adapter fits snugly against the lens.
5
ENGLISH
13
.
).
12
11 26
24
25