Spanset NoCut sleeve Borrador De Las Instrucciones página 16

3.5 Rotating sharp-edged loads
When fitted with NoCut
SpanSet lifting straps can be used to rotate sharp-edged loads (e.g.
coils). When it comes to lifting, the protective sleeve must be securely
fastened to the edge of the load and the lifting strap must be able to
move freely within the protective sleeve. When rotating by 90°, the
protective sleeve must only cover max. 2/3 of the pure strap length
between the loops, and when rotating by 180°, max. 1/2. Please also
refer to 3.4 Aligning the load.
Our technical support staff are happy to answer questions
concerning handling coils. Give us a call
4 Inspections, maintenance, repairs and decommissioning
NoCut must be inspected for visible defects and dangerous contami-
®
nants prior to every use. If a defect is identified that may compromise
safety, NoCut must not be used again. NoCut
®
one of the following defects is identified:
- Signs of heat impact
- Damage caused by aggressive substances such as acids and alkalis
- Contaminants from setting substances such as paint, adhesives etc.
- Partially or fully split yarns
- Cuts / holes / pinch points
- Fibre movement in the fabric / uneven fabric thickness
- Hardenings / crust-like surface compacting
- Uneven fabric width
- NoCut : Defect seams / fixing elements with limited function
®
pad
Repairs must only be carried out by the manufacturer or someone they
have commissioned For NoCut, repairs are limited to the fixing elements
of the NoCut
®
pad
is not possible. In this case, NoCut
be disposed of as domestic rubbish, insofar as the fabric has not been
contaminated with oils, operating materials etc. If the fabric has been con-
taminated with chemicals, NoCut
Page
EN
14
protective sleeves, 1- and 2-layer
®
sleeve
. If the cut-proof fabric on NoCut
®
®
may no longer be used. NoCut
®
must be disposed of as special waste.
®
!
15
must not be used if
is damaged a repair
can
®