Spanset NoCut sleeve Borrador De Las Instrucciones página 14

small width.
In the case of increasing lengths, NoCut
secured with additional fixing loops to prevent rotation. This is
the only way to guarantee that the lifting accessory is protected from
the cutting effect of the sharp edge. The fixing loops must not come
into contact with the sharp edge, but should be positioned in the
direct vicinity of the edge.
To affix the fixing loops for NoCut
20
I. Thread the NoCut
the cut protection fabric.
Il. Fixing loops are to be affixed onto the lifting material in line with
the principle of the fixing elements
3.2 Edge sharpness
Edge radii ≥ 1 mm: If there are edge radii of above 1 mm, NoCut
be used in line with this Operation Manual. Edge radii < 1 mm: In the
case of edge radii < 1 mm, the hoisting procedure must be planned
and executed with great care to ensure that the lifting equipment is
not damaged. Always contact your retailer or SpanSet for technical
support prior to using the product in this case and carry out a lift test
(slight lifting and moving) prior to use.
Please note the table provided on the pull-out
the following key:
a
Lifting straps
b MagnumPlus, SupraPlus, Twintex, Liftfix
c
MagnumPlus, SupraPlus, Twintex, Liftfix
d MagnumPlus, SupraPlus, Twintex, Liftfix
e
Magnum-X
f Magnum-X
g
EK
h EK
i
EK
Page
EN
12
through the strap loop (1) until it is lying on
®
pad
®
pads
®
pad
.
12
, which is defined by
18
≤ 20t WLL
≤ 30t WLL
≤ 50t WLL
≤ 20t WLL
≤ 30t WLL
≤ 20t WLL
≤ 30t WLL
≤ 40t WLL
should also be
can
®