Spanset NoCut sleeve Borrador De Las Instrucciones página 15

j
Radius
Layers
The values labelled as "x" in the table
radius for which the product from the NoCut
the head of the table can be used. Larger edge radii are included in
the respective labelling.
Never use NoCut
are uneven (e.g. perforations, steps, notches and splinters).
3.3 Selecting the correct size
Choose the correct size of NoCut
cross-section of the lifting accessory must not be constricted. Also
note that the width of the round sling will increase when subjected to
loads! When affixing NoCut
must be ensured that there is enough space for both cables, so that
they do not cross over or overlap
3.4 Aligning the load
Do not apply NoCut
ensure that they lie beneath the full width of the lifting accessory and that
the lifting accessory cannot slip onto the load's sharp edge during the lifting
process. Position NoCut
subjected to tensile loading during the lifting process. In the case of edge
radii ≥ 1mm, a settlement of maximum 30 mm is permitted between the
load and NoCut
®
prepared so that NoCut
during hoisting. The woven structure of NoCut
to a thickening of the fabric and a resulting fall in sleeve length. As such, an
excess length should be used in the case of rotating and turning.
If the sharp edge slides into NoCut
protective function. Falling loads pose a serious danger to
people and materials.
on edges with sharp ridges or on edges that
®
over both the cables of a round sling, it
®
to the load if it is twisted. When using NoCut
®
on the lifting accessory and load so that it is not
®
. In the case of smaller radii, the lifting process is to be
and the load cannot slide against once another
®
18
for your lifting equipment. The
®
.
14
may relax during use leading
®
it can lead to a loss of the
®
refer to the smallest
range named in
®
®
pads,
Page
13
EN