WillowWood One Manual De Instrucciones página 6

Ocultar thumbs Ver también para One:
Tabla de contenido
FIRST LAMINATION
If you are using PETG (Vivak):
1.
Place the model with the flexible socket in a
vacuum stand.
2. Apply a Nysert to the model. Twist the Nysert at
the distal end of the model and reflect the rest of
the Nysert back down onto the model. Smooth the
Nysert at distal end of the model.
3. Apply the One Sleeve Dummy, matching the edge
of the One Sleeve Dummy to the line drawn around
the flexible socket earlier. Wet the nysert before
pulling PETG.
4. Heat 1/8" (3 mm) PETG at 320° F (160° C) for 3
minutes, then flip and heat for 2 minutes.
5. Pull the PETG onto the model and cut the excess
as soon as possible.
6. Once cooled, sand the outer surface of the PETG
by hand for better adhesion.
7.
Apply putty and tape to the proximal cut to keep
resin out.
8. Proceed with the first lamination, using
standard practices.
9. Allow to cure. Proceed to page 7.
6
Nysert
Edge of One
Sleeve Dummy
even with
reference line
putty
Tabla de contenido
loading

Tabla de contenido