First Lamination - WillowWood One Manual De Instrucciones

FIRST LAMINATION

Follow the procedure listed below for the lamination method you are using:
If you are using ER Resin, follow the procedure below.
•
If you are using PETG, follow the procedure on page 6.
•
If you are using ER Resin:
1. Place the model with the flexible socket in a
lamination fixture.
2. Apply a Nysert to the model. Twist the Nysert at
the distal end of the model and reflect the rest of
the Nysert back down onto the model. Smooth the
Nysert at distal end of the model.
3. Prepare a seamless one-piece PVA sheet.
4. Apply the One Sleeve Dummy, matching the edge of
the One Sleeve Dummy to the line drawn around the
flexible socket earlier.
5. Lightly apply talcum powder to the One Sleeve Dummy.
6. Apply the PVA sheet and add vacuum.
7. Proceed with the first lamination, using standard practices.
8. Allow to cure. Proceed to page 7.
Nysert
One Sleeve
Dummy
5
Edge of One
Sleeve Dummy
even with
reference line