Second Lamination - WillowWood One Manual De Instrucciones

One Link
10. Apply putty to the screw head.
11. Thoroughly clean excess putty from the One Link Base.

SECOND LAMINATION

1. Apply 2 pieces of 3" (7.5 cm) wide masking tape to
the bottom of the 4-Hole Adapter. Trim the excess.
2. Transfer the socket to a lamination stand.
3. Secure the 4-Hole Adapter with 4 pieces of 1" (2.5 cm)
wide carbon.
4. Proceed with the second lamination, using standard
practices. Allow to cure.
Make sure there is
no putty on this lip.
10