Socket Finishing - WillowWood One Manual De Instrucciones

Ocultar thumbs Ver también para One:
Tabla de contenido

SOCKET FINISHING

1.
Draw the trim line on the laminated socket.
2. Draw a second line approximately 1/2" (1.3 cm)
above the trim line that was just drawn.
3. Sand to expose the One Link screw. Remove the screw.
4. Drill a 3/16" (4.8 mm) hole in the center of the
4-Hole Adapter, through both the laminated socket
and flexible socket, to create a vacuum port in the
flexible socket.
5. Separate and remove the socket from the plaster
model. If using PETG, be careful not to crack the
PETG when removing the socket from the plaster.
Trim line
1/2" (1.3 cm)
11
Tabla de contenido
loading

Tabla de contenido