Assembly With One Sleeve
6. Using a 7 mm socket, install the One Link Nut onto
the flange bolt. Tighten to 25 in lb.
Do not over-tighten.
Sand down the flange bolt if necessary so that it is
flush with the One Link Nut.
7.
Screw on the One Link Cap with O-Ring.
8. Perform a vacuum test to confirm that the socket
is airtight.
9. Fold the large end of the sleeve
down onto the socket to expose
the open end of the socket.
10. Have the patient step into the
socket and pull the sleeve up
onto the residual limb.
One Sleeve
16