Installation - Rivacold CO2NNEXT Instrucciones Para El Ensamblaje

Installation

EN
CAUTION: During the activities the operator must wear all the necessary personal
protective equipment (PPE).
DANGER: If the condenser unit is installed in an enclosed place, sufficient air
recirculation must be guaranteed. If installed in an enclosed place that does not
comply with this requirement, it is mandatory to equip the system with an audible-
visible signalling device that trips in the event of leakage of refrigerant gas.
DANGER: The brackets must be suitable in relation to the dimensions and weight of
the machine.
DANGER: Perform the required interventions using work tools up to norm (ladders,
various tools) and paying utmost attention to elements that could lead to tripping or
cause cuts and contusions.
Before installing the party completed machinery, it is necessary to draw up a project for housing of
the refrigerant system, in which the following details are specified:
 all components of the refrigerant circuit (e.g. condensing unit, evaporator, sizing of pipes,
safety components, if necessary, etc.);
 location of the plant;
 pipelines layout.
The partly completed machinery must be installed on the floor in a horizontally level position.
Alternatively, the partly completed machine can be mounted to raised brackets. The brackets are
not supplied with the unit.
Secure the partly completed machine to the floor (or brackets), interposing rubber antivibration
mounts.
Leave sufficient space around the machine to allow maintenance work to be carried out safely.
Assess the situation shown in the figure in relation to the recommended safety clearances.
After having installed the partly completed machinery, if the compressor is secured by brackets (to
protect it from damage during transport) free the compressor by removing the brackets.
56 / 168
Co2Nnext rev.00