Tabla De Contenido; Safety Precautions; Installation Location - McQuay A08019026011 Manual De Instrucciones

- Outline And Dimensions

- Installation Location

- Model Selection
- Schematic Diagram
- Electrical Wiring

- Safety Precautions

- Installation Location
- Unit Installation
- Physical Data
Before installing the air conditioner unit, please read the following safety precautions carefully.
• Installation and maintenance should be performed by qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing wiring work
according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazard due to insulation failure.
• All electrical wiring must not touch the refrigerant piping compressor and any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before installing or servicing the unit.
Please take note of the following important points when installing.
• Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates at the surrounding of the unit, it may cause fire ignition.
• Ensure that the drainage piping is connected properly.
If the drainage piping is not connected properly, it may cause water leakage which will dampen the
furniture.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.
• Ensure that the units panel is closed after service or installation.
Unsecured panels will cause the unit to operate noisily.
• This unit is designed for indoor installation only.
• Installation work should be done by authorized dealer or qualified contractor.
• Install the unit at a suitable minimum distance or shortest path to the coupling unit.
• There should be sufficient space for piping connection, service and maintenance.
• The area should be isolated from vibration and noise.
• Ensure the area is free from water leakage.
INDEX
page i-ii - Refrigerant Piping
page iii-iv - Electrical And Wiring
page iv - Electrical Data
page v-vii - Recommended Fuse And Cable Sizes
page viii-xii - Control Operation Guide
page 1 - Unit Operation Limits
page 1 - Service And Maintenance
page 2 - Troubleshooting
page 2
SAFETY PRECAUTIONS
! Warning
! Caution
INSTALLATION LOCATION
1-1
page 3
page 3
page 3
page 4
page 5
page 5
page 6
page 7