Domo DO725K Manual De Instrucciones página 49

· Finally, check the colour of the cream. Ideally, it should be a light brown colour and evenly distributed.
Does the coffee taste too bitter or too acid?
· The grinding coarseness is too fine.
· You use too much ground coffee in proportion to the amount of water.
· You tamped the coffee with too much force.
Does the coffee taste too weak or watery?
· The grinding coarseness is too coarse.
· You use too little ground coffee in proportion to the amount of water.
· You did not tamp the coffee hard enough.
STEAM NOZZLE
You use the steam nozzle to froth milk to achieve the perfect cappuccino or latte.
1. Fill the water reservoir. Insert the plug in the power socket and press the on-off button.
2. Fill a jug with cold, full-cream milk. Be careful not to overfill the milk jug. Frothing the milk will
increase its volume.
3. Place a collection beaker under the steam nozzle or turn it toward the drip tray. In standby mode,
turn the rotary knob to the preheat setting. The indicator will light flash, meaning the steam is now
heating up.
4. When the indicator light remains lit continuously, the appliance has warmed up. Turn the knob to the
max indication. First, a few drops of water will come out of the steam nozzle, then steam will form.
Turn the steam nozzle towards the milk jug.
! Note: the steam emitted by the steam nozzle is very, very hot, so keep your hands away from
the unit while it is in operation.
5. Bring the milk jug up to the steam wand and insert the steam nozzle a few millimetres into the milk.
As the milk expands in volume, keep lowering the jug slightly until the steam nozzle tip is just below
the surface of the milk. If you insert the steam nozzle too deeply into the milk, it heats the milk but
does not froth air into the milk and no foam will form.
! Note: do not use the steam feature for more than 5 minutes at a time.
6. When you obtain the desired amount of foam, turn the rotary knob to the off-position.
7. Clean the steam nozzle after every use.
! Note: the steam nozzle may still be really hot.
The unit must cool down after using the steam feature. Some vapour will drip onto the drip tray, which is
normal.
1
www.domo-elektro.be
2
3
MAX
PRE-HEAT
4
49
DO725K