Domo DO725K Manual De Instrucciones página 47

1. Hold the portafilter against the push button of the grinder support. Grinding will start. Hold the
portafilter against the button and do not release it until the desired amount of ground coffee is
reached.
2. You will hear a signal. The new amount of ground coffee for the grind button is now set.
! Note: the minimum grind time is 5 seconds. If you grind for less than 5 seconds, the unit will not
record that as the new amount. The standard factory setting will be retained.
Setting coffee volume
You can adjust the amount for the single and double buttons.
1. Press and hold the button down for which you want to set the volume (single or double).
2. You will hear a signal and preparation starts.
3. When you obtain the desired amount, release the button. The preparation stops and you will hear an
alert, which indicates that the amount is set as the new volume for the button.
Pressure gauge
If the pressure gauge indicates a pressure between 0 and 5 bar while brewing coffee,
the pressure is too low. In this case, check the following:
1. Are the coffee beans fresh?
2. Have you put enough pressure on the tamper? When pushing the ground coffee,
you should use a force of ±15-20 kg.
BAR
0
3. Select a finer grinding setting.
If the pressure gauge indicates a pressure between 12 and 20 bar while brewing
coffee, the pressure is too high. In this case, check the following:
1. Are the holes in the filter blocked?
2. Have you put too much pressure on the tamper? When pushing the ground
BAR coffee, you should use a force of ±15-20 kg.
0
3. Select a coarser grinding setting.
Restore factory settings
· If you want to restore the single button to its factory settings, press the hot water button and the
single button simultaneously until you hear a signal.
· If you want to restore the double button to its factory settings, press the hot water button and the
double button simultaneously until you hear a signal.
www.domo-elektro.be
1
OR
1
2
OR
3
47
DO725K