Step-By-Step Instructions - Dentsply Sirona SmartLite Focus Manual Del Usuario

3

Step-by-step instructions

3.1 Installation and charging (
1. Remove floor panel
).
Figure B2
2. Connect jack
3. Close floor panel (see
4. Make sure power socket used for power connector is accessible at all times in case
of necessary emergency disconnection.
5. Insert battery pack
(see
Figure A2
SmartLite Focus
®
6. To recharge the battery, insert the handpiece
(see
Figure B5
charging.
The SmartLite
®
operating time after 10 minutes recharging.
3.2 Operation
1. Protect LED tip from gross contamination by applying the single use SmartLite
Sleeves (see
2. Use the SmartLite
SmartLite Sleeves or use suitable, light filtering safety glasses (see
®
Always make sure SmartLite
Focus to avoid accidental aspiration (press SmartLite
®
rect position). Always make sure SmartLite
on SmartLite
).
Figure D4
3. Adjust the LED tip: The LED tip is rotatable by 330°, thus the position of light emission
may be individually adjusted. The LED tip must be adjusted to an angle that allows
optimal curing of the restoration. The LED tip should be positioned as closely as
possible to the restoration.
4. Polymerization: Briefly press the ON/OFF key [1.3.1 ON/OFF key]. Audible operation
signals are described in [1.3.3 Audible signals].
5. To stop curing light before the end of the 20 second cycle, press ON/OFF key at any
time. To cure a restorative material that requires a curing time longer than 20 sec-
onds, repeat activation by pressing the ON/OFF key after the end of each 20 second
curing cycle (see also [2.2 Precautions]).
6. Curing times for a range of Dentsply Sirona materials are outlined in the Curing
Guide provided. When using other products, please refer to respective product's
Directions for Use.
Procedure A
of charging base by lifting floor panel at its back end (see
3.1
to charging base socket
4.1
Figure B4
into SmartLite
2
and ).
Figure A3
battery pack is pre-charged and ready to use upon purchase.
®
). The battery light will be flashing green, indicating battery is re-
Focus Automatic Quick Charging Mode allows a minimum of 5 minutes
®
).
Procedure C
Focus Shields supplied with the unit in combination with mounted
® ®
®
Focus without covering the light aperture (see
® ®
and
Procedure B
(see
3.2
) and plug in power connector
Focus handpiece
® ®
Focus Shields are securely fixed to SmartLite
®
Focus
®
)
).
Figure B3
.
4
1
into the charging base
1
Focus Shield firmly into cor-
® ®
Shields are properly mounted
®
Figure D3
3
®
).
Procedure D
®
and
6